Publicidad
Idiomas disponibles
Idiomas disponibles
EN
E. Connect detector to your mobile phone
Step 1: A 2.4 GHz WiFi network is required to connect. If your
network broadcasts on both 2.4 and 5 GHz, disable 5 GHz
during the pairing process (as per your router manual).
Step 2: Install the Tuya Smart- or Smart Life-app on your
smartphone by scanning the QR-code on the right.
Figure 1: Add Device in app
05
Step 3: Enable Bluetooth via settings on your phone. The
app also needs permission to use Bluetooth.
Step 4: Activate pairing mode by pressing the test button
4 times within 1 second. If this is done correctly, the red
LED light will flash rapidly. After a few seconds this will
change to a green LED that flashes rapidly for 1 minute.
Within this minute you can link the detector to your app.
Step 5: Click on the "+" in the top right corner of the app
home screen. Then choose "Add device", as you see in
Figure 1. The app will now automatically look for devices
that are in pairing mode. Follow the steps as described in
the app.
If the app itself does not yet have permission to use
Bluetooth, click on the notification and follow the steps to
allow the app to access Bluetooth as you see in Figure 2.
Frequently Asked Questions
Alarm: If an alarm sounds when you try to activate
pairing mode, a test is activated because you did not
press fast enough. After the alarm stops, try pressing
the test button again 4 times as quickly as possible
within 1 second.
Low battery: The first time the detector is connected,
the app may incorrectly report that the battery is
almost empty. Disconnect the smoke detector and
then reconnect it. If the notification is given again by
the app, please contact us.
Figure 2: Turn on Bluetooth in app
Publicidad
