Protection Function - HTW P31 Serie Manual De Usuario

2. Operation instructions of remote control
The air conditioner can be controlled with the remote control. Two AAA-batteries are required to use the
remote control.
: Press the POWER button to turn the unit on and off.
POWER
: Press the MODE button to switch between cooling, dry, fan, heating modes.
MODE
UP : Press the UP button to increase the desired temperature and set the duration of
: Press the DOWN button to reduce the desired temperature and set the
DOWN
duration of the timer.
: Press the FAN button to cycle between low, medium and high fan speeds.
FAN
: Press the TIMER button to set the duration of the power on or power off
TIMER
SWING timer. : Press the swing button to change the orientation of the louvres
TEMPERATURE
to direct the air
UNIT
Fahrenheit.
: Press to turn on the sleep mode. The unit will work with energy saving logic and
SLEEP MODE
the lowest fan speed.
IV. Protection function
1: Frost Protection Function:
In cooling mode, if the temperature of the exhaust pipe is too low, the unit will automatically enter protection status;
if the temperature of the exhaust pipe rises to a certain temperature, it can automatically revert to normal operation.
2: Overflow Protection Function:
When water in the water pan exceeds the warning level, the unit will automatically sound an alarm, and the "FULL"
indicator light will flash. At this point, you need to move the drainage pipe connecting the unit or the water outlet to
sewer or other drainage area to empty the water (details see Drainage Instructions at the end of this chapter). After
the water is emptied, the unit will automatically return to the standby state.
3: Automatic Defrosting (heating models have this function):
The unit has an automatic defrosting function. Defrosting can be achieved through four - way valve reversing.
4: Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting protection function after the
compressor is turned off.
: Press to switch between displaying the temperature in Celsius and
26