ABB ReliaMod Instrucciones De Instalación

—
I N S TA L L AT I O N I N S T R U C T I O N S
ReliaMod™ Modular Metering
RHORNBYPASS
Kit Contains:
Horn Bypass Stab
—
ABB Inc.
305 Gregson Drive
Cary, NC 27511
United States
electrification.us.abb.com/reliamod
HAZARDOUS VOLTAGE .
WILL CAUSE SEVERE
INJURY OR DEATH.
Turn OFF power supplying this
equipment before working inside.
Line Side
Load Side
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With regard
to purchase orders, the agreed particulars
shall prevail. ABB Inc. does not accept any
responsibility whatsoever for potential
errors or possible lack of information
in this document.
Please read these instructions
completely before installing
or removing device. Improper
installation could be hazardous
to personnel and/or equipment.
• Turn "OFF" power supplying the meter module.
• Remove the meter cover and meter where the horn
4
bypass installation will be done.
• Remove the nut, lock washer, and washer from the Line
Side of the meter socket and retain for installation.
• Insert the horn bypass stab to the bolt on the Line
Side of the meter socket with the stab pointing out.
(See Image)
• Secure the horn bypass stab to the bolt with the nut,
lock washer, and washer.
• Torque nut to 170 in lbf.
We reserve all rights in this document
and in the subject matter and illustrations
contained therein. Any reproduction,
disclosure to third parties or utilization
of its contents – in whole or in parts – is
forbidden without prior written consent
of ABB Inc. Copyright© 2023 ABB
All rights reserved
Para consultar las instrucciones
en español, véase la página 2