Publicidad
Idiomas disponibles
Idiomas disponibles
The Remover is easy to handle thanks to its
design and the simplicity of its mechanisms. No
special training is required for handling the unit.
Use it according to the operating, maintenance
and safety instructions indicated in this manual
and follow the application methods indicated to
obtain the required quality of finish.
Before putting the unit into operation, and espe-
cially after each cleaning and/or repair opera-
tion, a check must be made that the equipment
components are securely tightened and that the
hoses are airtight (no leaks). Faulty parts must be
replaced or repaired as appropriate.
Ensure that the products to be applied are chemi-
When working under normal conditions, the mixer
must be positioned vertically on a uniform,
horizontal surface to avoid vibrations and guaran-
tee proper function.
INCORRECT INSTALLATION OF THE MACHINE
MAY CAUSE DAMAGE TO PEOPLE, ANIMALS OR
OBJECTS. THE MANUFACTURER CANNOT BE
CONSIDERED RESPONSIBLE FOR THESE DAMAGES.
7.1 TRANSPORT AND DISCHARGE
The remover is delivered packaged. It must be
transported and stored according to the indica-
tions on the packaging.
Due to the low weight of the remover can be
moved by two people without using other means.
7.2 ARRANGEMENT OF THE LIGHTING SYSTEM
The Client must make sure that there is suitable
lighting for the surroundings and that the lighting
conforms to the regulations in force. In particular,
the Client must arrange the positioning of lighting
that illuminates all the working area.
7.3 ARRANGEMENT OF THE PNEUMATIC SYSTEM
The Client must arrange a line of filtered com-
pressed air supplied by a compressor that is
suitable for the consumption required. Do not use
compressed air that contains chemical products,
synthetic oil with organic solvents, salts or corro-
sive gases as they can cause damage or malfunc-
tioning. The line of compressed air must arrive up
to the supply points of the machine. If the com-
pressed air contains a large amount of moisture,
5. WARNINGS
cally compatible with the components these come
into contact.
In order to make any check, repair or operation,
first disconnect the unit from the fluids network.
The premises must be ventilated, and there
should be no direct exposure to flame (cigarettes,
lamps, etc.)
Use safety goggles and sound shields
Any non-compliance with the indications set out
in this manual may lead to incidents affecting the
physical integrity of the user or other personnel or
animals.
6. USEFUL TIPS
The air supply to the pneumatic motor of the mixer
must be dry, lubricated and completely filtered
(see section 9 Lubrication).
For this purpose, we recommend using the
SAGOLA Purifier - Regulator - Lubricator model
7. INSTALATION
it may cause malfunctioning in the valves and in
the pneumatic components. Install a moisture
separator downstream from the compressor to
avoid this.
7.4. CLASSIFICATION ACCORDING TO THE ATEX
DIRECTIVE
The machine conforms to the essential requisites
of the EU Directive 2014/34/UE, better known
as ATEX ("Explosive atmospheres"). It is classified
as group II category 3 letter G system.
The assessment procedures of conformity, carried
out by an internal factory check, allow the insta-
llation of the machine in surroundings where
there may be potentially explosive atmospheres
due to the presence of gas, fumes or mist.
7.5. START-UP
1 - After ensuring that the mixer has been positio-
ned and secured correctly, connect the compres-
sed air hose to the alternating or rotary pneuma-
tic motor regulator.
- 18 -
II 2G x
Publicidad
