Publicidad
Idiomas disponibles
Idiomas disponibles
2 - Use the regulator of the SAGOLA Purifier-Re-
gulator-Lubricator to set the purified, regulated
and lubricated air pressure to your needs.
3 - Turn the motor regulator flywheel anticlockwi-
se to set the rotation speed to the desired revolu-
tions to keep the product properly stirred. To
Try to keep away from the spraying area remo-
ver. The fog produced in the spray, dust and
foreign bodies, are negative determinants in life
Remover.
When work has been completed, both the remo-
ver and the product cup must be cleaned with the
appropriate thinner, in order to remove any
remaining product.
It's advisable to grease union fittings make
Assembly to keep the threads in perfect condi-
tions of use.
Moving parts must be lubricated lightly after clea-
ning has been completed. We recommend you to
use a light SAE 10 oil or natural grease or vasoli-
ne.
Every 100 work hours, if the air drive is not oiled,
we recommend disconnecting the air hose and
put a few drops of light oil type SAE-20.
In order to carry out maintenance or repairs, first
disconnect the unit from the compressed air distri-
bution network.
Do not apply excessive force or inadequate tools
for maintaining and cleaning the unit.
Some repairs must be done with special tools on
some occasions. In these cases, you must contact
the Customer Service of SAGOLA.
reduce the speed or stop the engine, turn the
regulator flywheel clockwise.
You can check the functioning of the motor by
observing the movement of the square part that
rotates in the pneumatic motor.
8. CLEANING
Keep air gasket areas free of accretions and
foreign bodies.
Clean or replace, if necessary, the muffler of
engine air filter. A dirty or clogged filter reduces
significantly the revolutions of the engine.
9. LUBRICATION
Every 1000 hours of work, there is that grease
the joint of the piston and the shaft of the motor,
with fat of bearings of high quality (valid for
Remover alternative 471). Likewise and with
equal frequency piston with oil SAE-20 joints
must be greased. It must be checked that they are
sufficiently well wetted in oil and in good condi-
tion. Otherwise they should be replaced.
Have special care in tighten enough them screws
of mooring of the lid to avoid leakage of oil.
10. MAINTENANCE
Any handling of this product by non-authorised
personnel would render the warranty null and
void.
The unit must be overhauled on a periodic basis to
check the status of its components and replace
these when they are not in perfect condition.
IN ORDER TO OBTAIN THE BEST POSSIBLE
RESULTS, ALWAYS USE ORIGINAL SAGOLA
SPARES THAT GUARANTEE TOTAL INTERCHAN-
GEABILITY, SAFETY AND PERFECT OPERATION.
- 19 -
Publicidad
