Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING AND INSTALLATION
Perform the following procedure after installing
the control valve to verify proper operation:
• Set the minimum air pressure that allows the pump to
supply fluid to the control valve
• Check for leaks and that no fluid is dispensed through
the nozzle.
• Push the trigger. The fluid should be dispensed through
the nozzle once network air is eliminated.
OPERATING MODE
DISPENSED
To dispense fluid, proceed as follows:
1. Adjust line pressure until reach desired value.
WARNING: Do not exceed the maximum
!
equipment working pressure. See page of
technical specifications.
2. The gun has a safety lock system that prevents
accidental opening. If the cam located in the middle of
the trigger is in the anti-open position, place it in the
open position to begin dispensing.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
1
2
Fig. 2
• With the trigger at rest position, check that there are no
leaks and that fluid supply is stopped. Due to fluid
accumulation in the extension, fluid dripping may
occur after stopping dispensing.
EN
3
R. 03/23 896 854
Publicidad
