Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
the
Saw
Portable Mounting Using Clamps
• If necessary, clamp the miter saw to a workbench
or table top.
• Place two (2) or more "C" clamps on the clamping
areas and secure (Figure 15).
• Be careful
not to place clamps
over the base
extension clamping levers (Figure 15).
• Mounting with clamps will prevent access to some
wide miter angles.
Clamping
Areas
Clamping Areas
Figure 15. Portable Mounting Using Clamps
Adjusting
the
Four
Position
Switch
Handle
Setting
Main Handle
in Desired
Position
The switch handle can be positioned in any of four
different
orientations,
depending
on the
cutting
situation and user preference.
• vertical
• horizontal
• 45 ° Left
• 45 ° Right
To reposition the main handle:
1. Release handle clamp (Figure 16).
2. Pull and
hold
handle
rotation
release
lever
(Figure 16).
3. Rotate handle to desired location.
4. Let go over
release
lever to set handle
into
place.
Release lever will retract down only in
one of the four (4) positions
Note:
Power switch can not be actuated
unless
release lever is retracted down.
Do not attempt to
switch tool on between handle position, damage may
OCCUr.
5. Lock the handle clamp.
Adjusting
the Four-Position
Handle
Clamp Tension
1. Open handle clamp.
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by turning
to the
right. Always
adjust
both
setscrews by the same amount.
3. Close handle clamp.
4. Check the tension.
Handle
J
Handle Rotation
Release Lever
Figure 16. Setting Main Handle Position
18.
Publicidad
