Publicidad
Idiomas disponibles
Idiomas disponibles
Bevel Range 1 = 45 ° Left to 0 °
This left side bevel range is the default setting
To operate in range 1:
1. Move the left sliding fence to clear saw
assembly and re-lock (Figure 29).
_o
0
2. Lift bevel lock lever to the table height --v
with the left hand (Figure 30).
Left
3. Grasp the front carry handle with the
right hand and tilt saw head to angle
desired.
4. Once in the desired
bevel position, fully press
down
bevel
lock
lever
below
table
height
(Figure 29)..
Without
turning
the saw on, practice the cutting
action to make sure the fence clears the guards and
adjust as necessary.
Bevel Range 2 = 0 ° to 45 ° Right
To operate in range 2:
1. Move right sliding fence to clear saw
N.,A_
°
assembly and re-lock (Figure 29).
2. Lift bevel lock lever to the table height
Right
with the left hand (Figure 30).
3. Grasp the front carry handle with the left hand and
tilt saw head slightly to the left while rotating the
spring-loaded
bevel range selector knob with the
right hand so the symbol "45-0 °" lines up with the
arrow on the table (Figure 31). The saw assembly
may now be tilted to a right bevel angle up to the
45 ° stop.
4. Once in the desired bevel position press down
bevel lock lever below table height.
NOTE: When the saw assembly
is tilted back left
past 0°, the bevel control knob will snap back to the
default bevel range 1. This is designed to regain the
pre-set bevel stop at the important 0 ° position.
Bevel Range 3 = 47 ° Left to 47 ° Right
This full capacity bevel range setting overrides all
preset stops and allows for cutting at bevel angles
beyond the normal 45 ° on either side.
To operate in range 3:
1. Move left and right-sliding fences to
saw
assembly
and
re-lock47 '47
°"
clear
(Figure 29).
MaX
2. Lift bevel lock lever to the table height
with the left hand (Figure 30).
3. Grasp the front carry handle with the left hand and
tilt saw head slightly to the left while rotating the
spring-loaded
bevel range selector knob with the
right hand so the symbol " 47-47 ° " lines up with
the arrow
on the table
(Figure 31). The saw
assembly may now be tilted to any angle from 47 °
left to 47°right.
4. Once in the desired
bevel position, fully press
down bevel lock lever below table height.
Follow these instructions
for
making your bevel cut:
5. Extend the base extensions and fence on the side
on which the cut will be made. (See Sliding Fence
and Base Extension on page 22).
6. Properly
position
workpiece.
Make sure work
piece is clamped firmly against the table and the
fence.
Use clamping position that does not
interfere
with
operation.
Before
switching
on, lower head assembly to make sure
clamp clears guard and head assembly.
7. Follow the procedures for either a chop cut or slide
cut (see page 23).
8. Wait until blade comes to a complete stop before
returning
head assembly
to the raised position
and/or removing workpiece.
Front Carry
Handle
Sliding
Fence
Figure 29.
--
Bevel Lock
Lever
Figure 30.
Bevel Range Selector Knob
Figure 31.
25.
Publicidad
