Descargar Imprimir esta página

Bosch 5412L Instrucciones De Funcionamiento Y Seguridad página 12

Ocultar thumbs Ver también para 5412L:

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly
Tighten
the cover
plate screw.
Loose cover plate screw may inter-
fere with and hang-up lower blade guard. Never use
saw without
cover plate securely
in place. Lower
guard will not function properly.
9. Be sure the arbor lock is released so the blade
turns freely.
After
installing
a new
blade,
make sure the blade
does not
interfere
with the table insert at the 0 ° and 45 °
bevel positions.
Lower the blade into the table slot
and check for any contact with the base or turn table
structure. If blade contacts base or table, seek autho-
rized service.
10. Place multi purpose tool in rubber grommet in right
rear of tool.
Assembling
Dust Elbow And Dust Bag
1. With the miter arm locked in the down position,
push the dust elbow onto the dust port. Push the
dust bag onto the elbow and rotate both to desired
position. (Figure 4).
Dust
Port
Dust Bag
Dust Elbow
Figure 4. Dust Elbow and Dust Bag
2. Position dust chute/bag so that it does not interfere
with the tool during the cutting operation
for all
miter/bevel settings. Make sure dust bag does not
interfere with the slide rails during slide cutting.
3. The dust bag requires
emptying
when
full of
sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust
elbow.
Empty
dust
bag
in
proper
trash
bin by unzipping the bag. Be extremely careful of
dust disposed, materials in fine particle form may
be explosive. Do not throw sawdust on an open
fire.
Spontaneous
combustion,
may
in time,
result from
mixture
of oil or water with dust
particles.
Note: The dust port also accepts a standard 1-1/4"
vacuum tube for dust collection.
When sawing chemically
pressure
treated lumber, paint that may be
lead based, or any other materials that may contain
carcinogens,
use special precautions. A suitable res-
pirator must be worn by all personnel entering the
work area. Work area should be sealed by plastic
sheeting and persons not protected should be kept
out until work area is thoroughly cleaned.
12.

Publicidad

loading