Digital Projection TITAN 1080p-500/250, sx+-500, HD-500/250, XG-500
General precautions
Do not open the cabinet. There are no user serviceable parts inside.
Use only the power cable provided.
Ensure that the power outlet includes a Ground connection, as this equipment MUST be
earthed.
Take care to prevent small objects such as paper or wire from falling into the projector.
If this does happen, switch off immediately, and have the objects removed by
authorised service personnel.
Do not expose the projector to rain or moisture, and do not place any liquids on top of
the projector.
Unplug before cleaning, and use a damp, not wet, cloth.
Do not touch the power plug with wet hands.
Do not touch the power plug during a thunder storm.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
There are no user-serviceable parts inside the lamp module. The whole module should
be replaced.
Take care when removing the lamp module.
NEVER touch the lamp or refl ector.
Take care not to touch the glass surface of the lamp module. If you do accidentally
touch the glass, it should be cleaned before use. (see section 5. Maintenance.)
Do not use the lamp for more than 1500 hours, as this may cause serious lamp failure,
damage the lamp module and cause extra cost on replacement.
HID lamps produce high intensity light. Do not look directly at the light coming from the
lamp housing, or the lens, or allow items such as magnifying lenses to be placed in the
light path. This could result in serious eye damage.
Do not touch the ventilation outlets, as they will become hot in use.
Do not cover or obstruct the ventilation outlets or inlets.
Do not cover the lens whilst the projector is switched on. This could cause a fi re
Always allow the projector to cool for 5 minutes before disconnecting the power,
moving the projector or changing the lamp.
Never use strong detergents or solvents such as alcohol or thinners to clean the
projector and lens.
Rev E
March 2008
English
Page 5