Publicidad
Idiomas disponibles
Idiomas disponibles
Setting
Surface
Controls
General
Cooktop information
Use the chart below to determine the correct setting for the kind of food you are
preparing. The Simmer settings are used to simmer and keep larger quantities of foods
warm such as stews and soups. The lower Simmer settings are ideal for delicate foods
and melting chocolate or butter.
Note: The size and type of cookware used will influence the setting needed for best
cooking results.
Recommended
Settings
Table
.............................................
f°r Sing!e, Dual and Bddge surface
E!ements ..............................................................................................................
9(High)
5-8 (Medium high)
5(Medium)
2-4 (Medium low)
1-2 (Low)
Start most foods, bring water to a boil, pan broiling
Continue a rapid boil, fry, deep fat fry
Maintain a slow boil, thicken sauces and gravies, steam vegetables
Keep foods cooking, poach, stew
Keep warm, melt, simmer
Radiant
surface elements may appear
to have cooled after they
have been turned off. "H" will
appear in the display and will
continue to glow for 30
minutes or less. The glass
surface may still be hot and
burns may occur.
Do not place
plastic items such as salt
and pepper shakers, spoon
holders or plastic
wrappings on top of the
range when it is in use.
These items could melt or
ignite. Potholders, towels or
wooden spoons could catch
fire if placed too close to the
surface elements.
Operating
the Single
Radiant Surface
Elements
The cooktop has single radiant surface elements at 3 locations; right rear, left
rear and left front element positions. There is also a Bridge element that can be
connected to the left front element (See Bridge Element Operating instructions on
pages 10-11 ).
To Operate the Single Surface Elements:
1.
Place correctly sized cookware on the radiant surface element.
2,
3,
4,
Touch POWER pad (See Figure 3) for2 seconds, a beep will sound and steady
ON/OFF
"-" will appear in all displays. Touch ON/OFF pad (See Figure 2) of the selected
cooking surface and "0" will appear in the display. Touch iX. or V
pads
(See Figure 2) to set the element at the temperature desired. To instantly
reset temperature to "0" touch /X.
and V
simultaneously.
A beep will be
heard each time the pads are touched.
Start most cooking operations on a higher setting and then decrease to a
lower setting to finish cooking. Each surface element provides a constant
amount of heat at each setting. A glowing red surface heating area extending
beyond the bottom edge of the cookware indicates the cookware is too small
for the surface heating area.
When cooking has finished on any of the surface elements, touch ON/OFF pad
to turn OFF that element.
The indicator(s) will flash "H" when the cooktop is
ON but the element is turned OFF indicating that the surface may be hot to
the touch. The flashing "H" indicator will turn OFF after 30 minutes or less.
To switch the entire cooktop OFF touch and hold the POWER pad for 2 seconds
ON/OFF
(a beep will sound) and release. When the cooktop is powered OFF the "H"
will glow steadily indicating the cooktop may be hot to the touch. The "H"
indicator will turn OFF after 30 minutes or less.
ON/OFF
\
V
i
_ure
3
Figure
2
Note: The entire cooktop will automatically power OFF 10 seconds after all
surface elements have been turned OFF.
Note: See Recommended
Surface Element Settings Table above.
iF . .......
Publicidad
