Publicidad
Idiomas disponibles
Idiomas disponibles
Cooktop
Control
Functions
READ THESE iNSTRUCTiONS
CAREFULLY BEFORE USING THE COOl(TOP
.............
BRIDGE iNDiCATOR LIGHT- will glow when the Bridge element is selected.
BRIDGE ELEMENT CONTROL - Touch this pad to activate the Bridge element. The Bridge element will not
activate until the left front single element is also turned ON. (See page t0)
DUAL ELEMENT iNDiCATOR LIGHT - will glow when the Dual element is selected.
i?
_
Theouter
....................
..........
ON. (See page 10)
BOTI-
0
..........
O
POWER LEVEL & HOT SURFACE INDICATORS (4 locations) - These indicators show
the selected Power Level setting. Also, the indicators flash "H" when you turn an element
OFF but the cooktop is still ON, indicating that the cooktop surface is too hot to touch.
ELEMENTSELEMENTS
The "H" will glow steadily when you turn OFF the entire cooktop, also indicating that the
......... cooktop may be hot to the touch. In each case the "H" light will go out within 30 minutes.
...........................................................................
RIGHT REAR SINGLE ELEMENT ON/OFF - Use this pad to turn element ON or
OFF. Once the element is turned ON, use the Up or Down arrow pads to change
the Power Level settings. (See page 9)
V
O
O
POWER LEVEL UP & DOWN ARROW PADS (4 locations) - Use these pads to
.........................................................
..................................................................................................................
increase or decrease the Power Level settings to higher or lower temperatures.
The
temperature settings are from 1 (lowest) to 9 (highest). The 0 setting has no heat
ONIOFF
level.
......................................................................
LEFT REAR SINGLE ELEMENT ON/OFF - Use this pad to turn element ON or
OFF. Once the element is turned ON, use the Up or Down arrow pads to change the
V
A
Power Level settings.
C)C)
ON/OFF
................................................................................
LEFT FRONT SINGLE (& BRIDGE) ELEMENT ON/OFF - Use this pad to turn
element ON or OFF. Once the element is turned ON, use the Up or Down arrow
pads to change the Power Level settings. This element must be turn ON before you
V
A
connect the Bridge element to it.
C)C)
ON/OFF
.........................................................................
RIGHT FRONT SINGLE (& DUAL) ELEMENT ON/OFF - Use this pad to turn
element ON or OFF. Once the element is turned ON, use the Up or Down arrow
pads to change the Power Level settings. This element must be turned on before
V
A
you touch the Dual Element pad.
_
LOCK INDICATOR LIGHT- The Lock Indicator Light will glow when lock is properly activated.
COOl(TOP LOCK ON/OFF PAD - Use to disable all cooktop functions. Touch and hold pad
o
for at least 2 seconds to activate the Lock feature ON or OFF. The cooktop will not lock if
POWER
LOCK
................
O
_.
................ any element is in use. The Power to the entire cooktop must be turned OFF in order to Lock
the cooktop. Deactivate the Lock feature by touching and holding down for 2 seconds.
(See page11 )
COOl(TOP
POWER ON/OFF PAD - Use this pad to turn power ON or OFF to the entire
cooktop.
IMPORTANT: You must
power cooktop ON before any element may be used. To turn power ON you must press and hold the Power ON/OFF pad for at
least 2 seconds.
6
Publicidad
