Publicidad
Idiomas disponibles
Idiomas disponibles
element and "0" will appear in the display. Touch Uo pad (See Figure 1, on page 9) to
connect bridge element and then touch /_
or V
pads to set the temperature
desired. You may disconnect the bridge element at any time during cooking by
touching
_, pad. To instantly reset temperature to"O" touch /_.
and V
BEM_TS
simultaneously.
A beep will be heard each time the pads are touched.
3.
Start most cooking operations on a higher setting and then decrease to a lower setting
to finish cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small. Please note that not all cookware will
fit the Bridge element correctly.
4.
When cooking has finished on any of the surface elements, touch ON/OFF pad to turn
OFF that element.
The indicator(s) will flash "H" when the cooktop is ON but the
element is turned OFF indicating that the surface may be hot to the touch. The
flashing "H" indicator will turn OFF after 30 minutes or less.
To switch the entire cooktop OFF touch and hold the POWER pad for 2 seconds (a beep
ON/OFF
will sound) and release. When the cooktop is powered OFF the "H" will glow steadily
indicating the cooktop may be hot to the touch. The "H" indicator will turn OFF after 30
minutes or less.
Note: The entire cooktop will automatically power OFF 10 seconds after all surface
elements have been turned OFF.
Note: See Recommended
Surface Element Settings Table on page 9.
_Radiant
surface elements may
appear to have cooled
after they have been
turned off. "H" will appear
in the display and will
continue to glow for 30
minutes or less. The
glass surface may still
be hot and burns may
occur.
iF . .......
Surface
Controls
Lock Feature
It is possible to lock the surface element controls by touching and holding down on
LOCK
ON/OFF
pad for 2 seconds. One beep will sound and the Lock indicator light will glow when properly
activated.
Ii
To unlock the surface elements touch and hold down Loc, pad for 2 seconds. One beep
ON/OFF
will sound and the Lock Indicator light will turn off.
11
Publicidad
