Swiss+go MT-100 Manual página 8

Installing or Replacing Batteries:
We recommend using high quality batteries for the best product performance . Heavy duty or rechargeable batteries
are not recommended. The outdoor sensor requires lithium batteries in low temperature conditions.
Cold temperatures can cause alkaline batteries to function improperly.
Do not mix old and new batteries. Do not mix alkaline, standard, and/or rechargeable batteries.
Default settings
1. Default time: 0:00 (Time form: 24H)
2. Default date: 1/1 (Year: 2020, date form: D/M)
3. Default week: MIT (Language: GER, 7 languages can be selected)
4. Weather forecast: Partly Sunny
5. Default temperature: °C
6. Barometer unit: hpa
7. Default alarm: 00:00, default snooze time: 5min. The LCD display fully for 3 seconds when changing new battery or
resetting, then with a sound BI into the normal state, after testing temperature, receiving RF for 3 minutes.
Display / Keys Details:
There are totally 6keys for the alarm clock, they are included: MODE, SET, ALARM, RF, DOWN, UP, SNZ/LIGHT
1. MODE buttons:
a. Press MODE buttons to select Time, Alarm or Temperature alert setting mode.
2. SET buttons:
a. When check the Time, Alarm or Temperature alert mode, press and hold the SET buttons to enter the setting mode.
b. In normal mode, press SET button to select °C or °F
3. ALARM buttons:
Press ALARM button to turn on or turn off the alarms
4. RF button:
a. Press this button to select the channel.
b. In normal display mode, press and hold to search RF.
5. DOWN buttons:
a. Press to decrease the setting value during setting.
b. Press and hold 2 seconds button for fast adjust during setting mode.
c. In normal mode, Press and hold DOWN button for approx. 3 seconds to search for an RCC signal update.
6. UP buttons:
a. Press to increase the setting value during setting.
b. Press and hold 2 seconds button for fast adjust during setting mode.
c. In normal mode, press UP button to check Max and Min temperature and humidity memory.
d. In normal mode, press and hold UP button for approx. 3 seconds to clear the memory.
7. SNZ/LIGHT button:
a. Press this button to open backlight for 5 seconds (without adapter).
b. Press to activate the snooze function when alarming.
c. Press this button to adjust the backlight: HI
Automatic time setting:
After the power supply was established, the clock will automatically search for the radio signal.
This will take approximately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time will be set automatically and the radio
control signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press and hold the DOWN button for approx. 3 seconds to re-initialize radio signal reception.
2. If the device still not receiving the signal, the time must be set manually.
LO OFF (with adapter).