Publicidad
Idiomas disponibles
Idiomas disponibles
Calibration
Calibration verification
Midpoint and endpoint system method
1. Place the laser in the middle of a room with 5 metres between 2 of its walls.
2. Turn on the laser facing wall 1(P1) and mark the horizontal line (L1).
3. Rotate the laser 180° from its initial position without moving it from the spot.
The laser will face wall 2 (P2), the opposite wall to wall 1. Mark the horizontal
line (L2) on this wall 2.
4. Place the laser next to wall 1 and align the horizontal beam at the exact height
of the first marked line (L1).
5. Turn the laser 180°, projecting the horizontal light on wall 2. Mark the
horizontal line (L3) again on wall 2.
6. If the distance between L2 and L3 (d) is more than 2mm you must calibrate
your laser.
7. You can repeat this same system with the vertical axes.
Step 1 and 2
NIV20.indd 33
L1
33
29/4/22 10:59
Publicidad
