Publicidad
Idiomas disponibles
Idiomas disponibles
17. Follow all local electrical and safety codes, along with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA) guidelines must be followed.
18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will reset
itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the hose is
not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of water quickly,
and also check that all hose connections are tight to minimize leaks.
21. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
PRE-INSTALLATION
APPLICATION
This pump can be used as a submersible utility pump. It is suitable for draining or removing water from the following:
pits, sinks, window wells, basements, swimming pool covers, boats, low spot in yards, or other flooded areas.
This pump can be also used as a non-submersible transfer pump. It is suitable for draining or removing from the
following: flooded area, clogged sinks, water beds, water basins, boats, stock tanks, etc.
This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. This pump is
not designed to function as a permanently installed sump pump. It is also not engineered to be run continuously as a
"fountain" or "waterfall" pump.
Do not use where water recirculates.
Not designed for use as a swimming pool drainer.
Function:
Operating water depth: minimum 1 in.
MATERIALS REQUIRED (NOT INCLUDED)
NOTE:
The hose and hose kit are not shown to scale.
SPECIFICATIONS
Power supply
Liquid Temp. Range
Discharge
Power Cord
For Professional Technical Support call 1-844-242-2475
Garden Hose
115V, 60 HZ., 10 Amp Circuitminimum
32 to 95° F (0- 35° C)
3/4 in. garden hose thread
SJTW, 18AWG/3C, 10 ft.
3
Publicidad
