AquaPRO 54071-0 Manual Del Usuario página 6

1. Attaching the suction hose to strainer
Attach the clear suction hose to the suction strainer by pushing

the male threaded end into the rubber coupler on the suction
strainer.
Then, place the strainer in at least 1 in. of water at the lowest

point to be pumped.
NOTE:
Make sure the connection is airtight. An air leak can cause
the pump to run dry.
2. Attaching hoses

Open the bottom cover.

Thread the other end of the suction hose to the inlet of the pump.

Thread a 5/8 in. garden hose (sold separately, 50 ft. max. length) onto the
discharge outlet of the pump.
NOTE:
Always ensure the washer in the hose bib is not
damaged. An airtight seal is necessary for this pump to
operate.
NOTE:
Make sure the end of the outlet hose is not under
water. If the outlet is under water, the pump may not work.
NOTE:
Do not coil or kink the hose.
3. Priming water

Unscrew the priming plug.

Fill water through priming hole as the picture shows until to overflow.

Tighten the priming plug.
6 For Professional Technical Support call 1-844-242-2475