Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING
THE EDGING
DEPTH
_WARNING:
Never attempt to ad-
just the cut depth when the engine is
running. Always release the throttle trig-
ger, wait until the blade stops turning,
move the powerhead
ON/OFF switch to
the OFF position, and disconnect
spark
plug (or disconnect from power source)
before making adjustments.
Depth
Knob
._
1. Loosen the depth adjustment
knob.
2. Slide the wheel to the desired posi-
tion.
• Raising the wheel will increase
the cutting depth.
• Lowering
the wheel will decrease
the cutting depth.
3. Tighten the depth adjustment
knob
securely.
MAINTENANCE
SCHEDULE
_,
WARNING:
Always stop unit and disconnect
spark plug wire (or discon-
nect powerhead
from power source) before performing
maintenance.
CARE AND MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and decals
Check or replace blade
GENERAL
RECOMMEN
DATIONS
The warranty on this attachment
does
not cover items that have been sub-
jected to operator abuse or negli-
gence. To receive full value from the
warranty, the operator must maintain
the edger attachment
as instructed
in
this manual.
CHECK
FOR DAMAGED
OR
WORN PARTS
Contact Sears Service
Center for re-
placement
of damaged
or worn parts.
• Blade Shield - Discontinue
use of
edger if blade shield is damaged.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Blade nut
• Fasteners
INSPECT
AND CLEAN UNIT AND
DECALS
• After each use, inspect complete
unit for loose or damaged
parts.
Clean the unit and decals using a
damp cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
BLADE MAINTENANCE
_,WARNING:
Tile blade will con-
tinue to spin after the engine stops or
after the throttle trigger has been re-
leased. To avoid serious
injury, make
sure the blade has stopped
coasting
and disconnect
the spark plug (or dis-
connect
powerhead
from power
source)
before performing
work on the
blade.
,_&WARNING:
Always replace a
blade that is bent, warped, cracked,
broken, or damaged
in any other way.
Never attempt to straighten
and reuse
a damaged
blade. Use only specified
replacement
blade. Wear protective
gloves when handling
or performing
maintenance
on the blade to help
avoid injury.
• The blade is reversible.
When the
cutting edge on one side becomes
worn, turn the blade over (see
BLADE REPLACEMENT in the SER-
VICE AND ADJUSTMENTS section).
• Check blade for flatness periodically.
Lay the blade on a flat surface to in-
spect for flatness. Throw away a
blade that is not flat.
Publicidad
