Power Dynamics Professional Audio PDSM100 PA Manual De Instrucciones página 4

9. INPUT
6.3mm balanced line inputs for 8 channels.
10. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord. For instructions on how to change the fuse, see
"REPLACING THE FUSE".
11. ST 2 / AUX
Use to set the signal routing of the ST 2/AUX bus.
ST 2: routes the input signal directly to the ST 2/AUX bus after ST 2/AUX
controls. In this position, there is no effect on ST1 bus.
AUX: routes the input signal to the ST 2/AUX bus after firstly being adjusted
by ST 1-, then ST 2/AUX controls.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
OPERATION
1. Set all volume controls to minimum value.
2. Switch on audio source(s).
3. Switch on the PDSM100 mixer.
4. Switch on amplifier(s).
5. Increase volume on audio source(s).
6. Increase the volume on the mixer to low level.
7. Slowly turn up the volume on amplifier(s).
8. Adjust volume settings as desired.
Turn off: always turn off amplifiers first, then mixer and finally audio sources.
4