EFALOCK Professional Classic Style Manual página 11

Cutting length setting.
The cutting head can be perfectly adjusted to length with the aid of the drawing below.
Adjust cutting head in length.
Step 1: Click the cutting head of the device by pressing the cutting head on the top (the cutting part).
(1,2)
Step 2: All you need is a screwdriver and tweezers.
Step 3: Carefully move, with tweezers, the 2 springs to the side, next to the plate.
Step 4: Loosen the 2 screws.
Step 5: Now you can move the top blade to the correct length. Make sure that the blade does not
come over the other blade to prevent injury.
Step 6: Now tighten the screws again.
Step 7: And put the springs back in place.
Step 8: Finally, click the cutting head back on the device. (4)
1
Adjustment of the cutting length using attachment combs.
The attachment combs can be placed on the cutting head for different cutting lengths. These

are supplied with the device, in sizes 1/2/3mm./ 1.5/3/4.5/6mm.
These are clicked onto the device. (5)
Cleaning and maintenance.
To maintain the optimum cutting performance of the appliance, you should regularly
maintain the device. The best thing is cleaning and oiling every day.
 Switch off the device and disconnect it from the mains.
Remove the comb attachment from the cutting head, if in use.
Remove all hair and other contaminants with the supplied brush.
Carefully remove the cutting head from the device. (1)
Oil the cutting head; if you use the device regularly, we recommend that you do this before each use.
Oil all the parts of the cutting head that come in contact with each other. (3)
2 3 4
11
ENGLISH
5