Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
"d
u
TUNER
Press TUNER/BAND
repeatedly
to select
the
desired
band, FM or AM.
When TUNERIBAND
is pressed while the power is off, the
power is turned on directly.
Press +
DOWN or -
UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, [11011)is displayed.
TUNE
([mm])
To search for a station
quickly
(Auto Search)
Keep +
DOWN or *
UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press 4
DOWN or ~
UP.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast
contains
noise
Press MONO TUNER on the remote control so that "MONO
appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again so that
"MONO disappears.
To change the AM tuning
interval
The default setting of the AM tuning interval is 10 kHzLstep. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNEFVBAND.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
MULTI JOG
,
0-9, +1o
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1 Press the TUNER/BAND
to select
a band, and
press +
DOWN or ~
UP to select a station.
2 Press II SET to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Preset number
>
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
for all the bands have already been stored.
Use the remote control to select the preset number directly.
1
2
Press TUNEWBAND
to select a band.
Press numbered
buttons
O-9 and +1 O to select a
preset number.
Example:
To select preset number 15, press +10 and 5.
To select preset number 20, press +10, +10 and 0,
Selecting a preset number on the main unit
Press TUNER/BAND
to select a band. Then, press 4>
DIRECTION/PRESET
repeatedly or turn MULTI JOG.
Each time DIRECTION/PRESET
is pressed, the next higher
number is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
1 CLEAR, and press II SET within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
13
ENGLISH
Publicidad
