Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 CH INPUT
jacks
of this unit support
the DOLBY
DIGITAL
SURROUND
system.
Connect
a DVD player with 5.1 CH output jacks to this unit using
cables with RCA phono plugs as follows:
DVD player's
jack
This unit's
jack
5.ICH
OUTPUT
FRONT (L, R), etc.
5.ICH
FRONT (L, R)
5.ICH
OUTPUT
REAR (L, R), etc.
5.1 CH REAR (L, R)
5.1 CH OUTPUT
CENTER,
etc.
5.1 CH CENTER
5.1 CH OUTPUT
SUB WOOFER,
etc.
5.1 CH WOOFER
LINE OUT (L, R), etc
VIDEO/AUX
(See -.)
/'7 /
VIDEOI
AUX IN
LI
n -
mm
T
m
If the DVD is not connected
to Vi DEO/AUX
IN jack of this unit,
the sound from the connected
DVD player cannot be recorded.
To remove this limitation,
connect
the LINE OUT jacks of the
DVD player
to VIDEO/AUX
IN jacks
of this
unit
besides
conencting
to 5.1 CH INPUT jacks. The signals through VIDEO/
AUX IN jacks enable the recording
to be done. Refer also to
the operating
instructions
of the DVD player.
DOLBY
DIGITAL
SURROUND
sound cannot
be recorded
in
any way.
VIDEOI
AUX
MANUAL
SELECT (TEST)
VIDEOIAUX
M
DOWN,
w
UP
When a DVD player is connected
to the 5.1 CH INPUT jacks of
this unit, you can listen to DOLBY DIGITAL SURROUND
sound,
which enables you to enjoy theater-quality
sound in your home.
7 Press VIDEO/AUX
repeatedly
until "5.1 ch IN" is
displayed.
2
Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
m
The
DOLBY
PRO
LOGIC,
BBE and the SURROUND
are
automatically
canceled
when the 5.1 CH is selected.
Make sure the software
played back with the connected
DVD
player support
the DOLBY
DIGITAL SURROUND.
The function
is changed
from the 5.1 CH to the VIDEO when:
- the headphones
are plugged
in.
- the MIC or ECHO level is changed.
- the Rhythm
play function,
the SURROUND
system,
the
DOLBY
PRO LOGIC or the Karaoke
function
is turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
Use the remote control.
1
2
3
Press VIDEO/AUX
repeatedly
until "5.1 ch IN" is displayed.
Press MANUAL
SELECT
(TEST)
repeatedly.
Speaker
names appear in turn as follows:
r
L/R (Speaker balance) _
CEN: Center speaker
S-R: Surroundspeaker
_
S-L: Surround speaker J
(Right)
(Left)
Press -
DOWN or ~
UP to adjust the sound level while
"CEN", "S-L" or "S-R
is displayed.
Each level can be adjusted
between
-8dB and +7dB.
Repeat steps 2 and 3 to adjust each speaker's
surround
level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL
SURROUND
is changed,
that of the SURROUND
system
(page 9) and the DOLBY
PRO LOGIC
(page 20) are
also changed.
27
ENGLISH
Publicidad
