Parkside Performance PSSAP 20 Li C4 Guía Rápida página 33

m
CAUTION! RISK OF INJURY!
Saw blades can be sharp and become hot during
use. Always wear protective gloves when handling
saw blades.
m
CAUTION! RISK OF INJURY!
Do not use any blunt, bent or damaged saw blade.
u
Always install a suitable saw blade for the job.
u
Inserting the saw blade
(Fig. F)
Turn the chuck ring in a counter-clockwise direction.
2 ] [
Insert the saw blade into the saw blade holder
Release the chuck ring
2 ] [
position.
Before use: Pull on the saw blade and check if it is inserted
safely and tightly.
Removing the saw blade
(Fig. G)
Turn the chuck ring in a counter-clockwise direction.
[ 2 ]
Pull the saw blade out of the saw blade holder
Release the chuck ring
2 ] [
position.
NOTE
For certain work, the saw blade can also be inserted
u
after turning through 180°.
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when handling or
working with the product.
m
CAUTION! RISK OF INJURY!
Before switching on the product: Ensure the saw blade
u
is not in contact with the workpiece.
Ensure your stance is stable. Always hold the product's
u
front and rear handle
9 ] [
while working (Fig. H).
Keep your hands away from the saw blade when the
u
product is in operation.
NOTE
The on/off switch cannot be locked.
u 6 ] [
.
[ 3 ]
and let it return to its original
.
3 ] [
and let it return to its original
firmly with both hands
7 ] [
(Fig. I)
Switching on: Release the switch lock
in on the left or right side.
Press and hold the on/off switch
Regulate the speed as required (see "Speed control").
Switching off: Release the on/off switch
When releasing the on/off switch, the switch lock
moves back into its original position.
˜ Speed control
By using the on/off switch
control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
the immediate working area to improve visibility in poorly lit
areas.
The LED work light lights up automatically as soon as
[ ]
the product is switched on.
NOTE
The LED work light
u [ ]
approx. 10 seconds after switching off the product.
˜ Trial run
NOTE
Always carry out a no-load trial run before starting work
u
and after every saw blade replacement. Switch the
product off immediately if the saw blade is not running
smoothly, if considerable vibration occurs or if you hear
abnormal noises.
by pushing it
[ 5 ]
.
6 ] [
.
[ 6 ]
5 ] [
, you can progressively
6 ] [
Speed
Lower
Higher
to illuminate
[ ]
stays on for an additional
GB/IE 33