EN /
I
How to use this controller on Xbox
Connect the USB cable to an unused port on your Xbox console. Take care not to touch
the sticks or triggers when switching on the controller. If your console is off, press the
Xbox button on your controller to turn on the console or press the X button on your Xbox.
Once the status LED (no. 2) is solid White. You're ready to play!
The controller will switch off as soon as the USB cable is unplugged.
NOTE: from time to time we may update the software, of our products, to enhance the
gaming experience. Please check our website www.nacongaming.com regularly for any
updates.
I
How to use this controller on PC
The Evol-X PRO controller is a Plug-n-Play device. The necessary driver software will be
automatically installed when the controller is first connected to your computer. Here is
the detailed procedure to follow:
• Turn on your computer, wait for it to start, and go to your Windows desktop.
• Find an unused USB port on your PC and plug the USB cable of your Evol-X PRO
controller into it.
• Windows will detect the new device and, after a few seconds, start installing the
appropriate drivers. The process will be indicated by a small icon in the task bar.
• The installation takes more or less time depending on the speed of your system.
At the end of the process, the following message will appear: «You can now use
your Evol-X PRO. »
I
How to change the LED effects
The controller includes 20 preset light effects and to switch between them you just have
to do a short press on the multifunction button.
Keep pressing the button to cycle through the different effects. When you find the one you
want stop pressing the button. Note that when you reach the end of the LED effects the
LEDs will turn off. Just press the button again to turn them back on.
I
How to map the shortcuts
Press and hold the multi-function button for 3 seconds.
The status LED will flash.
Then press the shortcut button that you want to map, followed by the button that you
want to assign to that shortcut.
Repeat the process for each shortcut.
To reset the mapping on the shortcut double press it.
To finish the mapping, press and hold the multi-function button for 3 seconds.