Warranty Statement - Walter ICECUT300 Manual De Instrucciones

4. Operate the slide up and down a few times to test the movement and make any further necessary
adjustments. Try to ensure that all the screws are exerting a uniform pressure on the slide from top to
bottom. A perfectly adjusted slide will operate freely up and down without any sideways movement.
5. Now raise the slide to its highest position. Slightly undo the arbor bearing bracket and, using fingers only,
tighten the screws.
6. Place the machine on a steel plate, connect to power supply and switch on the magnet. Start up the motor. If
the arbor is incorrectly aligned, the arbor support bracket will be seen to oscillate. Make any necessary
further adjustments to the bracket to ensure correct alignment of the spindle and finally tighten the screws
using a spanner. Lastly tighten the arbor bearing bracket.
Check machine's grease.
The gearbox grease should be checked once a month to ensure all moving components are covered to prevent wear.
The grease should be changed at least once a year to ensure you gain the best from your machine.
Check Armature of the machine.
This should be checked at least once a month to check that there are no visual signs of damage to the body or to the
commutator. Some signs of wear will be seen on the commutator over a period of time but this is normal (this is the
part that comes into contact with the brushes) however, if there are any signs of abnormal damage the part should be
replaced.

19) WARRANTY STATEMENT

Walter warrants its machines to be free from faulty parts, under normal usage of machines, for a period of 12
months from initial date of purchase. All other parts (excluding cutters) are under warranty for 90 days, provided
that the warranty registration card (or online registration) has been completed and returned to Walter or its
designated distributor within a period of (30) days from the purchase date. Failure to do so will void the warranty.
If the stated is adhered to, Walterwill repair or replace (at its option) without charge any faulty items returned.
This Warranty does not cover:
1. Components that are subject to natural wear and tear caused by the use is not in accordance with the
operator's instructions
2. Defects in the tool caused by non-compliance with the operating instructions, improper use, abnormal
environment conditions, inappropriate operating conditions overload or insufficient servicing or maintenance.
3. Defects caused by using accessories, components or spare parts other than original Walter parts.
4. Tools to which changes or additions have been made.
5. Electrical components are subject to manufacturer's warranty.
Your online registration can be submitted at
The warranty claim must be logged within the warranty period. This requires the submission or sending of the
complete tool in question with the original sales receipt which must indicate the purchase date of the product. A
complaint form must also be submitted prior to the return.
This can be found online at www.walter.com.Failure to complete this form will result in the delay of your claim.
All goods returned defective must be returned pre-paid to Walter, in no event shall Walter be liable for subsequent
direct, or indirect loss or damage.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, (EXPRESSED OR IMPLIED) INCLUDING ANY WARRANTY OF
MERCHANTABLITY OR FITNESS FOR A PARTICULAR PURPOSE. WALTER RESERVES THE RIGHT TO MAKE
IMPROVEMENTS AND MODIFICATIONS TO DESIGN WITHOUT PRIOR NOTICE
www.walter.com
"ONLY THE BEST"®
17