Specifications - Walter ICECUT300 Manual De Instrucciones

4) SPECIFICATIONS

ICECUT 300
Maximum hole cutting capacity into steel = 75mm dia. x 75mm deep.
Arbor bore = MT3.
Voltage
Normal full load
Electro Magnet
Size
Holding Force at 20°C with 25mm minimum plate thickness
The use on any material less than 25mm thick will progressively reduce
the magnetic performance. If possible, substitute material should be
positioned under the magnet and work piece to equate to a suitable
material thickness. If this is not possible, an alternative secure method of
restraining the machine must be used.
Total Load (magnet + motor)
Height - maximum extended
Height - minimum
Width (including capstan fitting)
Length Overall (including guard)
Net Weight
Ear and eye defenders must be worn when operating this machine. Wear gloves to protect hands when operating the
machine.
The declared vibration total value has been measured in accordance with a standard test method and may be used for
comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
The vibration emission during actual use of the power tool can differ from the declared total value depending on the
ways in which the tool is used;
The need to identify safety measures to protect the operator that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of the operating cycle such as the time and when the tool is
switched off and when it is running idle in addition to the trigger time).
Suitable only for a single phase 50-60Hz A.C. power supply
Do not use your magnetic drill on the same structure when arc welding is in progress.
D.C. current will earth back through the magnet and cause irreparable damage.
WARNING: THIS APPLIANCE MUST BE GROUNDED!
NB: ANY MODIFICATIONS TO THIS MACHINE WILL INVALIDATE THE WARRANTY
Motor Unit
Overall Dimensions
DO NOT USE ON D.C. SUPPLY
7
120V 60Hz
15.0 A 1600 W
0.97 A 102W
220mm long
114mm wide
18500N
1702W
723mm
538mm
214mm
375mm
25.8kgs