FTE univers U7000 Manual De Usuario página 56

Follow next steps for the correct installation of this receiver.
STEP 1: OUTPUT VIDEO CONFIGURATION
In order to correctly visualise the reception signal on TV, you must configure the format and mode of
the video output.
- Video output mode: In order to get a correct visualization of the image select "HD" video output.
- Output format. You will be able to select among the following formats:
720P_60, 1080I_25, 1080I_30, 1080P_50, 1080P_60 or AUTO.
Q: There will be no any video&audio output via HDMI when switch the Video Output to
"SD" or switch the Display Mode to "576I" or "480I" on some TV set.
A: Because the TV set itself does not support the display resolution on 576I&480I. When
it happened, there is a recovered way with double press the YELLOW Key from RCU.
The interval between the double press should not be too long, or it will do its own action
as normal.
STEP 2: CONNECTIONS
The coaxial cable, with satellite signal, must be connected to the "IF IN" connector. The "HDMI" con-
nector must be connected to the TV set.
Depending on the type of installation, the receiver should be connected and configured following next
examples.
Example 1 – Basic System
QUICK INSTALLATION GUIDE
QUICK INSTALLATION GUIDE
PAG. 3
480I, 576I, 576P, 720P_50,
Example 2 – DISEqC switches