Publicidad
Idiomas disponibles
Idiomas disponibles
Using the dispenser without the water filter
You can run the dispenser without a water filter cartridge.
Your water will not be filtered. If you run the dispenser
without a water filter cartridge, keep the cartridge cap and
replace it in the base grille for future use.
1. Remove the water filter cartridge (See "Changing a
water filter cartridge" earlier in this section.) Then slide
the cartridge cap off the end of the filter cartridge. DO
NOT DISCARD THE CAR
2. With the cartridge cap in the vertical position, insert the
cap into the base grille until it stops.
3. Rotate the cartridge cap to a horizontal position.
NOTE: The cartridge cap may not be even with the
base grille.
To remove shelves from the shipping position (shelves
are shipped upside down):
1. Grasp front of upper shelf with one hand and use other
hand to remove packing material from shelf area.
2. Lower front of upper shelf until shelf hooks can be
removed from slots in shelf supports on the back
refrigerator wall. Pull shelf forward to remove.
3. Flip shelf over.
4. Insert rear shelf hooks into slots in shelf supports.
5. Tilt front of shelf up until rear hooks drop into slots.
6. Lower front of shelf. Check to make sure that shelf is
securely in position.
Slide-out
shelves
(on some models)
Some shelves slide out, providing easier access to foods
stored in back.
To slide out shelf, carefully pull front of shelf toward
you.
To slide in shelf, push shelf in until it stops,
Ordering
replacement filters
To order more water filter cartridges, call 1-800-366-PART
and ask for accessory Part #4392857.
The shelves in your refrigerator are adjustable to meet your
individual storage needs.
Storing similar food items together in your refrigerator and
adjusting the shelves to fit different heights of items will
make finding the exact item you want easier. It will also
reduce the amount of time the refrigerator door is open,
and save energy.
IMPORTANT:
Do not clean glass shelves with warm water
when they are cold. Shelves may break if exposed to
sudden temperature changes or impact. For your
protection tempered glass is designed to shatter into many
small pebble-size pieces. This is normal.
NOTE: Glass shelves are heavy. Use special care when
removing them to avoid impact from dropping.
To remove a shelf from the metal frame:
1. Pull shelf out to the stop.
2. Tilt front of the shelf up and pull it out a little further.
3. Lift up shelf so that it moves through the slot in the
frame.
Replace the shelf in the reverse order.
Shelves
and shelf
frames
To remove a shelf/frame:
1. Tilt up front of the shelf/frame.
2. Pull shelf/frame.
To replace a shelf/frame:
1. Guide the rear shelf hooks into the slots in the shelf
supports on the back refrigerator wall.
2. Tilt up front of shelf/frame.
3. Lower the front of the shelf into position.
16
Publicidad
