GE KTC-511P Manual De Instrucciones página 8

Installation Instructions
2 C
ONNECTIONS
See Figure 7 and perform the following:
To power
supply
Figure 7. Back panel connections
Attach the monitor's video in BNC connector to the camera's VIDEO OUT connector.
AC 24V/DC12V model (Low Voltage Version)
This terminal accepts both AC 24 V and DC 12 V (non-polarity), with Class 2 isolated power supply
AC 85V~265V model
The camera is equipped with a wide-ranging power supply. The unit can accept an AC power source
input from 85 VAC to 265 VAC
Note:
Power is now being supplied to the camera, and the power LED illuminates. If the LED is not
illuminated, check the terminal block connections and power source.
3 A
DDITIONAL
Back Focus To adjust the lens use the included screwdriver, turn the back focus thumbwheel screw
counterclockwise (unlock) so that the back focus thumbwheel turns. (See Figure 1.). Adjust the lens'
focal position by turning the back focus thumbwheel to achieve the sharpest image.
After adjustment use the screwdriver to lock the thumbwheel screw
3.1 DD L
EVEL
When the lens mode switch is set to DD, you can set the lens iris level adjustment to ensure the correct
exposure depending on the camera's position and the lighting levels. (See Figure 2.)
3.2 MON OUT (BNC)
The monitor output BNC connector can accept the BNC connector of a local monitor or of a monitor
used to test camera setup.
8
Power LED
A
DJUSTMENTS
( DC-
FOR TYPE LENSES
)
To local
or test
monitor
To
monitor