Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4 Connecting Procedures
Turn off your computer.
Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS/2 or compatible models
Rear view
O 15-pin mini
D-Sub cable
© Connect the supplied signal cable to the
monitor's port.
@ Connect the other end of the AC power
cord to a power outlet.
B. Apple computer
@ Use a UNIMAC-82D MAC adapter.
Panasonic MAC adapter
If you need an adapter and one is not provided
by your dealer,
call 1-800 PANASYS (1-800-726-2797).
Caution:
To prevent the cable from coming loose,
the cable connectors must be securely
fastened with screws,
Vertical
sync
signal
C. BNC connector signal computer
Rear view
En
@ AC power
5]
cord
O
@ BNC signal cable
@ Connect the BNC signal cable (Not supplied) to the monitor's port.
@ Connect the other end of the AC power cord to a power outlet.
@ Connection of AC Power Supply
If the AC power supply voltage is in the range 100 to 240V, either 50Hz or 60Hz frequency can be used.
There is no AC100V/240V selector switch as selection is automatic.
Precaution:
+ In order to use the display unit safely, use a power cord that is properly grounded.
+ AC plug cords for the following countries are supplied in the same package.
weavers
Canada....CSA
For use in other countries, make sure the AC cord meets the safety standards of each country.
Publicidad
