Hama Black Line Plus Instrucciones De Uso página 6

Note – Faulty transfer of measured
values
• In this case, you must resynchronise the stations by
brie y removing the batteries from both stations and
reinserting them.
• If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
• If necessary, select a new location for the base station
in order to avoid possible interference in the future.
5.1 Automatic setting using the DCF signal
• After switching on the base station for the rst time and
successfully transferring data between the base station
and outdoor sensor, the clock automatically starts the
search for the DCF signal. The radio symbol (7) ashes
during the search process.
• When the wireless signal is received, the date and time
are automatically set.
Note – Time settings
• The search process takes about 7 minutes. If the search
fails, it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1:00 a.m. and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
5.2 Backlight
• If you press the SNOOZE/LIGHT button (F), the display
will light up.
• During battery operation, the display is illuminated for
approximately 10 seconds.
5
Note – Permanent backlight
Permanent backlight mode is only possible when the
base station is plugged into mains power.
6. Care and Maintenance
Note
Disconnect the device from the power supply before
cleaning it or if it is not going to be used for a long
period of time.
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• Make sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.