Sears Craftsman EZ3 917.259581 Manual Del Propietário página 21

SE V E ND
CAUTION:
@
@
o
o
BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress ¢lutcWbrake pedal fu#y and set parking brake.
Place gearshi_ _ever in neutra_ (N} position.
Place attachment cWutch in "D_SENGAGED" position.
Turn ignition key "OFF" and remove key.
Make sure the blades and aH moving parts have completely stopped.
Disconnect spark p_ug wire from spark plug and p_ace wire where it cannot come in contact with
plug.
TO REMOVE MOWER (See Fig° !8)
Mower wi!! be easier to remove from the right side of tractor.
° Place attachment clutch in "D_SENGAGED" position,
o Move attachment lift lever foPward to lower mower to its
lowest position.
o Roll belt off engine pulley,
o Disconnect dutch rod from clutch lever by removing
retainer spring.
• Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
Disconnect front links from deck by removing retainer
springs.
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
TO INSTALL MOWER (See Fig. 18)
• Raise attachment lift lever to its highest position.
, Slide mower under tractor with discharge guard to right
side of tractor,
, Lower lift lever to its lowest position.
• Install mower in reverse order of removal instructions.
SPRINGS
(BOTH SIDES)
RETASNER
SPRING
ANTFSWAY BAR
RETAINER
SPRINGS
(BOTH SIDES}
F_Go18
21