Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Locate the gas regulator (1-1). Grasp the regulator (1-1) with
the knob (1-2) facing directly up. Line up the collar on the
regulator (1-1) with the open end of the burner tube (1-3) as
shown in fig. 1.
2. Screw the regulator (2-1) into the open end of burner (2-2)
as shown in fig. 2.
3. Once the regulator is in as far as it will go, tighten with a
wrench. Turn the regulator so that the knob is facing forward.
4. Note: Always make sure the regulator is secured in the fully
lock-in position before attaching propane cylinder.
5. Be sure the gas control knob (3-1) is in the "OFF"
position. Check to make sure threaded areas on cylinder
and regulator are clean. Screw the propane cylinder
onto the regulator (3-2) making sure to engage threads
correctly to achieve proper connection. To remove the
propane cylinder, unthread the cylinder from the
regulator (3-2) as shown in fig.3.
Note: It is normal for the regulator to swivel/
rotate back and forth at 360 degrees.
Fig. 1
(1-3)
(1-1)
(1-2)
Fig. 2
(2-2)
(2-1)
Fig. 3
(3-2)
(3-1)
6
Publicidad
