Trevi SCD 5725 BT Manual De Uso Y Conexiones página 14

ENGLISH
5. To search for stations with a PTY (PROGRAM TYPE) program
Press and hold PTY button to select one of PTY programs such as: POP M- - NEWS
-- off. While selecting POP M or NEWS, pressing one of 6 preset buttons briefly and
repeatedly can select your desired PTY program as described in preset buttons.
The 6 number buttons are shared as follows:
PTY music group --------------------- PTY speech group
1. POP M, ROCK M
2. EASY M, LIGHT M
3. CLASSICS, OTHER M
4. JAZZ, COUNTRY
5. NATION M, OLDIES
6. FOLK M
When turning on a PTY program, the PTY program and PTY word is flashed on LCD.
After selecting a desired PTY program and no operation for 2 seconds, it will search
for the station of the PTY program. During 1 loop, if the desired station of the PTY
program is not found, PTY NONE is displayed, then returns to previous normal radio
and PTY icon disappears.
6. AF [ALTERNATIVE FREQUENCIES] BUTTON
When AF switching mode is selected and the state of AF switching
mode is displayed by AF segment in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not received yet.
When AF switching mode is selected, the radio checks the signal strength of AF all the
time. The interval of checking time of each AFs depends on the signal strength of the
current station, from a few minutes for strong station to a few seconds for weak station.
Every time that new AF is stronger than current station, it switches over to that frequency
for a very short time, and the NEW FREQUENCY is displayed for 1-2 seconds.
Because the mute time of AF switching or checking time is very short, it is almost
inaudible in case of normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only
receive and save RDS program.
7. TA [TRAFFIC ANNOUNCEMENT] BUTTON.
When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA
SEEK will be displayed on LCD for a while.
When traffic announcement is transmitted:
1). If the unit is in SD, USB mode, it will switch to radio mode temporarily.
2). If volume level is below 20, volume level is raised to 20, and returns to its previous
mode and volume level when the traffic announcement is over.
If volume is adjusted during traffic announcement, only the traffic announcement
volume is valid
1. NEWS, AFFAIRS, INFO
2. SPORT, EDUCATE, DRAMA
3. CULTURE, SCIENCE, VARIED
4. WEATHER, FINANCE, CHILDREN
5. SOCIAL, RELIGION, PHONE IN
6. TRAVEL, LEISURE, DOCUMENT
Page 5
14
SCD 5725 BT