Trevi SCD 5725 BT Manual De Uso Y Conexiones página 16

ENGLISH
9. Tracks search
Press BAND button, it will activate TRACK SEARCH mode . The LCD will
display TRK 0/00/000(deside on the total number of tracks in the SD card or
USB stick) and flash the 0 on the biggest digit position. Then rotate VOL knob
to select a number on the flashing digit position from 0 ~ 9. Then press SEL
button to confirm the number and flash the 0 on next smaller digit position.
With the same means, select the number on the flashing digit position with
VOL knob. After finishing selecting the numbers on all digits position, press
1/>||/TOP button to play the track of the selected serial number.
BlueTooth Handfree System:
1. Pairing
Turn on Bluetooth mode of mobile phone, then select the function for Finding
Bluetooth Device and enter it. After finishing finding, it will show the name of
Bluetooth Device if found, select it and enter it, then it will show an interface
that asks you to input password. Input the password 0000 and enter it. then
the LCD of the car audio system will display BT READY .
2. Connection or disconnection
A) Use mobile phone to do connection or disconnection
1) In connection status, find the paired and connected Bluetooth Device, then
press the disconnection button to do disconnection.
2) In disconnection status, find the paired and disconnected Bluetooth Device,
then press the connection button to do connection.
B) When powering on (after Acc of the car was switched off ), the unit will search
for the once connected mobile phone, pair and connect. This will take about
10-15 seconds.
Note:
(1) Bluetooth icon appears on LCD only when in connection status.
(2) In connection status: Mobile phone transfers to car audio player whenever a
dialling takes place; Mobile phone transfers to car audio player whenever
receiving a call.
3. Dialling when in connection status
To make a call simply press the TEL button and enter the number you wish to
call using the mobile phone. When your ready to make the call press TEL
again, to end the call simply press hang up button.
4. Accept/ Reject/ End Call
A) During ringing, press TEL button to accept the call.
B) During ringing, press hang up button to reject the call.
C) During talking, press hang up button to end the call.
5. Talking volume level setting
Whlie talking, use volume control to adjust volume level, but this volume
level can not be saved.
Page 7
16
SCD 5725 BT