Trevi SCD 5725 BT Manual De Uso Y Conexiones página 17

ENGLISH
6. Dialling or receiving calls while the unit is in sleep mode
When the car radio is in standby mode (Acc on and Power off), when dialling
or receiving a call, the car radio will power on automatically. After the call is
completed, the radio will revert to standby mode.
7. To transfer the audio of a file played by Mobile Phone to the Car Audio Player
If the mobile phone supports A2DP and could play audio or video files, when
the Mobile Phone plays an audio file(For some Mobile Phones, you must first
select Play by BT ), the playback will be transferred to the Car Audio Player.
In A2DP mode, if the Bluetooth device of the Mobile Phone supports AVRCP,
the functions of the >>|, |<< and PLAY/PAUSE buttons are the same as one
in media mode(no fast forward/backward functions for the >>|/|<< buttons).
The other buttons normally available in media mode are not available.
INSTALLATION METHOD
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
METAL SUPPORT STARP
DASHBOARD
METAL MOUNTING SLEEVE
To remove the unit out of the metal mounting sleeve,
insert the two supplied KEYS into the left and right side
slots of the chassis at the same time. Then pull the chassis
out of the metal mounting sleeve as shown in the right
illustration.
To boost up the capability of anti-jamming,
please make sure fix tightly the metal support
strap into the metal joint that connect to the
chassis of the car.
UNIT CHASSIS
FIXED FACEPLATE
Page 8
17
SCD 5725 BT
Bend the tabs on the metal mounting
sleeve against the DASHBOARD with
a screwdriver
F O R NT PANEL
PLASTIC TRIM RING