Hilti Nuron C 4-22 01 Manual De Instrucciones página 18

▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a portable battery charger for Hilti Li-ion batteries with a rated voltage of 21.6
volts. It is designed to be connected to power outlets providing an AC (alternating current) voltage of 100 to
127 volts or 220 to 240 volts (depending on country-specific version).
The charger can be set on a flat surface or mounted on the wall.
• The Hilti Li-ion batteries approved for use with this product can be found in this list.
• Not all batteries are available in all markets.
Product information
Charger
Generation
Serial no.
3.3 Operating status indicator of the charger
Status
LED shows green.
LED doesn't light.
3.4 Status indicators of the Li-ion battery during charging
When a Hilti Nuron Li-ion battery is connected to a Hilti charger, the status indicator of the battery shows
the state of charge and also fault messages, if applicable.
Status
One (1) LED slow-flashes green
14 English
1
C 4­22
01
1 - 99999999999
Battery
@
Battery status indicator
;
Battery release button
=
Charger operating status indicator
%
Holes for wall-mounting
&
Battery interface
(
Meaning
Charger is ready for use.
Charger is not ready for use.
Meaning
The battery is being charged, state of charge:
≤ 20 %
2292547
*2292547*