Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Control LEDs on the charger (31):
green
red
lights up
—
—
lights up
—
flashes
flashes
flashes
Operation
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
NOTICE! Risk of damage! An incorrect
battery can damage the device and bat-
tery.
Inserting the battery
1. Push the battery (13) along the guide
into the battery holder (10).
Operating mode Symbol
Impact drilling
Drilling
Screw
Switching on and off
Switching on
1. Use the function selection switch (5) to
select an operating mode.
2. Select the direction of rotation with the
rotation direction switch (7).
3. Select a gear with the gear selector
switch (6).
36
Meaning
• Battery is fully
charged
• stand-by (No
battery inserted)
Battery is charging
Battery is over-
heated
Battery is defective
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release (14)
on the battery (13).
2. Pull the battery out of the battery hold-
er (10).
Selecting the operating
mode
Notes
• Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the workpiece by your hand or
against the body leaves it unstable and
may lead to loss of control.
• Only operate the function selector
switch when the tool has stopped.
Procedure
Set the function selector switch (5) so that
the arrow mark points to the desired sym-
bol.
Material
Concrete, Stone
wood, metal, plastic ⭮
Screwing in and un-
screwing
4. Use the torque adjustment ring (3) to
select a maximum speed.
5. Press and hold the On/off switch (17).
The LED work light (15) lights up.
Switching off
1. To turn it off, release the on/off switch
(17).
Direction of rota-
tion
⭮
Screwing in: ⭮
Unscrewing: ⭯
Publicidad
