Descargar Imprimir esta página

Beper P203TFO110 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Double Size Electric Blanket Use instructions
After each use, turn the appliance off and always unplug it from the
wall socket.
Do not leave the appliance operating unattended; before leaving the
room, make sure it is off and disconnect the plug from the wall socket.
The appliance must be intended only for the use for which it was
expressly designed. Any other use is to be considered improper and
thus dangerous.
Warning: this heated blanket is not suitable to be used in ho-
spitals; this is not a medical device. Do not use the heated
blanket for children, sick people or people insensitive to heat.
Warning: Keep this appliance out of the reach of children.
The appliance must not be used by persons (including children) with
limited physical, sensitive or mental capabilities, or by persons that
lack knowledge or experience, unless properly surveilled or unless
they have been given full and accurate instructions on the safe use
of the appliance and the risks connected to its use.
Only for indoor use.
Do not leave the appliance exposed to atmospheric agents (rain,
sunlight, etc.)
Check the appliance thoroughly before using it, to make sure there
are no signs of wear or deterioration.
Do not use the heated blanket folded. Do not fold it, roll it or wrinkle
it; keep it always lying flat.
Do not use pins or other sharp objects to secure the blanket to the
mattress. The blanket must not be tucked in.
Do not activate the temperature control with wet hands.
Do not pull the power cord or the appliance itself to remove the plug
from the socket.
Always disconnect the appliance from the mains supply before cle-
aning or performing maintenance and when the appliance is not in
use.
If the appliance if faulty or malfunctions, switch it off and do not tam-
per with it. Any repairs must only be carried out by an authorized
technical service center.
If the power cable is damaged it must be replaced by an authorized
technical service center, so as to prevent all risks.
10

Publicidad

loading