Concept RK4100 Manual De Uso página 19

EN
PRODUCT DESCRIPTION
A Lid of the kettle
B The strainer
C Glass body of the kettle
D Body of the kettle
E Lid opening button
F Handle
G Delete the current one in the image and replace it
H Base
A
B
C
D
NOTICE:
Before first use, we recommend boiling the maximum volume of water at least 3 times and pour it out. Afterwards, the
kettle is ready for use.
The kettle may only be used with the supplied base.
36
DISPLAY DESCRIPTION
1 Temperature icon
2 Temperature for white tea
3 Temperature for green tea
4 Temperature for Oolong tea
5 Boil button
6 Temperature setting
7 POWER button
E
2
4
F
6
7
G
H
OPERATING INSTRUCTIONS
1. Remove the kettle from the base, open the lid and fill it with cold water (the water level must be within the MIN-
MAX watermarks inside of the kettle).
2. Place the kettle on the base. The electrical contacts will connect automatically. Thanks to the central connector
design, the kettle can turn around 360° and can be placed on the base from any side.
3. Connect the base to the mains. You will hear a sound signal, all the indicators will light up for a moment and then
the current temperature will remain lit. The kettle is ready for use.
4. By pressing the 5/BOIL button, the kettle automatically boils water to 100 °C.
5. If you want you can choose a temperature between 40°-100°. Press the Temperature control +/- button repeatedly
until the desired temperature lights up on the display. The kettle will then start automatically after 2 seconds.
6. The kettle will automatically switch off after reaching a boiling point or the set temperature.
7. Remove the kettle from the base and use the water.
8. If you need to reheat the water that has just been boiled, wait approximately 30 second before switching on the
kettle again.
1
Button 2/ White:
Press the button briefly to raise the temperature to 70°.
Button 3/ Green:
3
Press the button briefly to raise the temperature to 80°.
Button 4/ Oolong:
Press the button briefly to raise the temperature to 90°.
5
Note:
• A few drops of water appearing on the base of the kettle after use is not a sign of a defect. It is a small amount of
condensed water, which deactivates the kettle thermostat.
• The kettle has a KEEP WARM function - Press the 7/ Warm button and the icon will flash. Then use the 6 buttons to
set the desired temperature. After setting the temperature, the kettle will automatically switch on after 2 seconds
8
and maintain the desired temperature for 2 hours.
Button 8/ Power:
If no key is pressed for one minute, the kettle automatically switches to standby mode. The key symbol flashes. Press
the key to activate the other keys. If you press the key for 5 seconds, the kettle returns to standby mode.
CLEANING AND MAINTENANCE
Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet! Make sure the appliance has
cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse it in water!
Descaling
During normal use, deposition of impurities from water occurs. Use commercially available descaling agents to clean
them (follow the manufacturer's instructions).
Note: Remove the deposits regularly, approximately once a week, depending on the water hardness and frequency of
use. The deposits significantly reduce the heating capacity and the lifespan of the appliance.
EN
37