Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
The power tool has been designed for the
following cutter types:
• Profile cutter, ⌀ 25 mm, R 4 mm
• Rounding cutter, ⌀ 22 mm, R 6.3 mm
• V-groove cutter, ⌀ 12.7 mm, ∡ 90°
• Groove cutter, ⌀ 12 mm
• Groove cutter, ⌀ 6 mm
• Fillet cutter, ⌀ 22 mm, R 6.3 mm
Any other use that is not expressly permit-
ted in this instruction manual may pose
a serious hazard to the user and result in
damage to the device. The operator or
user of the machine is responsible for any
accidents or personal injury and/or mater-
ial damage to third parties or their prop-
erty. The machine is intended to be used
by do-it-yourselfers. It was not designed
for heavy commercial use. The warranty
is void in the case of commercial use. The
manufacturer is not liable for damage
caused by improper use or incorrect oper-
ation.
Scope of delivery/
accessories
Unpack the device and check that
everything is present.
Dispose of the packaging material prop-
erly.
• Router
• Adapter for external dust extraction
• Parallel guide
• 2×Sliding bar
• Collet chuck, 8 mm (pre-assembled)
• Collet chuck, 6 mm
• 6-part cutter set
• Template guide
• Centring tip
• Open-end wrench
• Hex key
• Translation of the original instructions
22
Overview
The illustrations for the
device can be found on
the front and back fold-out
page.
1 Lever
2 Handle
3 Direction of rotation arrow
4 Step limit
5 Spindle lock
6 Coupling nut
7 Collet chuck, 8 mm
8 Baseplate
9 Wing screw
10 On/Off switch
11 Switch lock
12 Power cord
13 Rotary wheel
14 Collet chuck, 6 mm
15 Parallel guide
16 Retaining screw
17 Jaws
18 Sliding bar
19 Depth stop
19a Controller
20 Adapter for external dust extraction
21 Screw
22 Open-end wrench
23 Locking screw
24 Hex key
6-part cutter set
25 Profile cutter (⌀ 25 mm, R 4 mm)
26 Rounding cutter (⌀ 22 mm,
R 6.3 mm)
27 V-groove cutter (⌀ 12.7 mm,
∡ 90°)
Publicidad
