Flama 1676FL Manual De Instrucciones página 14

Replacing the dust bag
If the bag status indicator turns on, check
and, if necessary, replace the dust bag.
Press on the release pedal and lift the lid of
the dust bag compartment.
Remove the dust bag; discard it or empty it
if it is a reusable bag. The dust bag should
be disposed of conscientiously and with
care.
Substitute with a new bag.
Close the lid and the dust bag lid.
Note: The bag status indicator can also flash
if there is a blockage. In this case, check for
the cause of the blockage.
FILTERS
The motor protection filter (placed next
to the bag) should be removed and rinsed
with water twice per year or whenever
visibly clogged. If the filter is damaged, it
should be replaced with a new filter.
If the filter is worn, it must be cleaned in
a timely manner. To do so, remove the
grille and shake the filter to remove the
accumulated debris.
Afterwards, return the filter and grille to
their original position.
To maintain the good performance of your
vacuum, the motor protection filter and
exhaust filter (HEPA) should be washed
after the bag has been replaced 5 times.
Hand wash the filters in warm water and
allow them to dry completely before
returning them to the vacuum.
Note: Do not use hot water or detergents. If
the filters should become damaged, replace
them.
Do not attempt to use the vacuum without
its respective bag and filters being installed.
14
ANOMALIES AND REPAIR
In case of malfunction, please take the
appliance to an authorized Technical
Assistance Service. Do not attempt to
disassemble or repair the appliance, as this
may be dangerous.
PROTECTING THE ENVIRONMENT
use, recycling and other forms of recovery
in order to reduce its negative effects on
the environment.
When it is no longer in use, this appliance
must not be disposed of together with
other unsorted municipal waste.
The user is responsible for delivering it
free of charge to the selective collection
facilities available for that purpose.
Pieces of equipment that are no longer in
use can also be taken back at points of sale,
by purchasing new pieces of equipment
that are equivalent and have the same
functions.
For more detailed information on collection
points, please contact your City Council or a
point of sale for this equipment.
www.flama.pt
This symbol indicates the
separate collection of electrical
and electronic equipment.
The main objective of the
separate collection of this
waste is to reduce the quantity
to be disposed of, promote re-