English
ADD LIGHT SOURCES TO YOUR
STEERING DEVICE:
Before you can use your light
source you'll need to pair it with a
steering device.
To add more light sources, just
repeat the steps below:
1. Make sure that your light source
is installed and the main power
switch is turned on.
2. Hold the steering device close to
the light source you want to add
(no more than 5 cm away).
3. Press and hold the pairing
button
seconds. A red light will shine
steadily on the steering device.
Your light source will begin to
dim and finally flash one time
to indicate that it has been
successfully paired.
Up to 10 light sources can be
paired with 1 steering device.
Make sure to pair them one at a
time. If the light sources are close
to each other, disconnect those
for at least 10
6