GE Zoneline AZ9VH Manual Del Propietario Y Instrucciones De Instalación página 33

Troubleshooting Tips... Before you call for service
FAULT CODES - Press and hold MODE, then press AUX
Fault Code Fault Meaning
Numbers
2
3 External thermostat wiring. Applied signal is not valid and has been constant for
temperatures.
5 Outside thermistor fault.
One of the outside thermistors is not reading valid temperatures.
running.
7
minute of running.
Software fault.
minutes.
N/A
Outlet thermistor failure. Fault clears when thermistor reads value other than short
circuit or open circuit.
temperature drops below threshold.
fan operation and check unit/ductwork for blockage.
23 Make-up Air Module Fault. Fan is not operating as expected
25
27
clears when readings are valid.
invalid. Fault clears when readings are valid.
are valid.
Communication fault with 2 way thermostat
32
running normally.
49-5000640 Rev. 2
Effective on system operation while
fault is active
No resistance heating, fan, heating pump or
cooling available.
No heat pump or cooling available.
Resistance heating and fan only.
No external control of fans, heat and cooling
internal control operation only.
No cooling or heat pump operation available.
Resistance heating and fan only.
No cooling or heat pump operation available.
Resistance heating and fan only.
No effect.
No cooling or heat pump operation available.
Resistance heating and fan only.
No effect.
temperature recovers.
temperature recovers.
Heat pump and resistance heating are shut
down and restarted when the indoor ambient
temperature cools sufficiently.
No effect.
No resistance heating available.
N/A
No resistance heating available.
No resistance heating available.
No resistance heating available.
No effect
No effect
operation. Modifies defrost termination target
cycles.
Customer has no control of unit
Unit will ignore faulty thermostat sensor data
and use internal sensors
allows compressor to restart
33