Publicidad
Idiomas disponibles
Idiomas disponibles
If
oven is used in a new branch circuit installation
(1996 NEC), mobile
home, recreational
vehicle,
or
where
local codes DO NOT permit connecting
the
appliance
cable ground wire to the power supply
cable neutral
(white)
wire you must use a 4 wire
power
supply cable (see figure
12):
1. Disconnect the power supply.
2. In the circuit breaker, fuse box or junction box:
Connect appliance and power supply cable wires as
shown in figure 12.
Ground
Cable from Power Supply
Wires
Ground Wire
(I
Green Wire)
Junction Box
Wire
U.L-Listed
Conduit Connector
(or CSA listed)
Cable from appliance
Figure 12
4-WIRE GROUNDED JUNCTION BOX
DO NOT ground to a gas supply pipe. DO NOT connect
to electrical power supply until appliance is permanently
grounded. Connect the ground wire before turning on
the power (Figure 12).
NOTE TO ELECTRICIAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature
rating of household wiring. The
current carrying capacity of the conductor is governed by
the temperature
rating of the insulation around the wire,
rather than the wire gauge alone.
Range
Placement
To eliminate the risk of burns or fire from
reaching over heated surface units, cabinet storage
space located above the range should be avoided. If
cabinet storage space is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally
a minimum of 5" (12.7 cm) beyond the
bottom of the cabinet.
o
Center
Line of
Range
O
Follow instructions
for
the type of installation
you have
Figure 13
If range will be installed
with a cabinet
on both
sides, draw a center line on the floor between the
cabinets (see figure 13). If back of range will not be
flush with the wall (the location of the outlet may not
allow the range to be positioned against the wall), draw
a line on the floor where the back edge of the range will
be. Now install anti-tip bracket (see "Anti-Tip Bracket
Installation",
page 12).
If range will be installed
with a cabinet on one side
only, move the range into final position. Draw a line on
the floor along the side of the range that is not against
the cabinet. If back of range will
not be flush with
the wall (the location of the outlet may not allow the
range to be positioned against the wall), draw a line on
the floor where the back edge of the range will be. Now
install anti-tip bracket (see "Anti-Tip Bracket
Installation",
page 12).
If range will not be installed
against
a cabinet,
move range into final position. Draw a line on the floor
along both sides of the range. If back of range will not
be flush with the wall (the location of the outlet may
not allow the range to be positioned against the wall),
draw a line on the floor where the back edge of the
range will be. Now install anti-tip bracket (see "Anti-Tip
Bracket Installation",
page 12).
Publicidad
