WEG WCD-SWU serie Manual Del Usuario página 15

Installation
DIN-rail Mounting.
„
You can also mount SWU-5-Tx/8-Tx on a standard DIN-rail by below steps. The DIN-rail kit is
screwed on the industrial switch when out of factory. If the DIN-rail kit is not screwed on the
industrial switch, please screw the DIN-rail kit on the switch first. First, hang the SWU-5-Tx/8-Tx
to the DIN-rail with angle of inclination. See figure.
Then, let the device down straight to slide over the rail smoothly. See Figure.
14 | WCD-SWU