Publicidad
Idiomas disponibles
Idiomas disponibles
17026986_0310 ASR 2050 NAFTA.book Seite 8 Freitag, 19. März 2010 9:54 09
ENGLISH
ENG
Children should be supervised to ensure that they
do not play with the tool.
--------------------------------------------------
Steam cleaners and high-pressure cleaners must
not be used to clean the vacuum cleaner.
The inside of the cover must always be kept dry.
Mold contamination can result if the appliance is
not cleaned for an extended period, especially if
used in areas where foodstuffs are processed:
Always clean and disinfect the vacuum cleaner
immediately after use.
Never open the appliance outdoors during rain or
storms.
Never sit or stand on the appliance.
Arrange the cables and hose so that no-one can
trip over them.
The appliance must not be operated in areas with
an explosion hazard.
Never insert or remove the mains plug with wet
hands.
Only pull on the mains plug, not on the lead.
Observe the applicable regulations in your country
for the filter cartridges. The filter cartridges (made
of polyester) that are contained in the delivery
comply with dust class M (filters trap 99.9 % of all
dusts as of Ø 3 µm). HEPA filter cartridges see
chapter10 Accessories.
The total maximum permissible current
consumption (of dust extractor and connected
unit) must not exceed the value I
page 2). You can reduce the current consump-
tion of the vacuum cleaner with the "Current
Control" feature, and thus adapt it to the on-
site conditions. See chapter 6.2. If the current
consumption is too high, the vacuum cleaner or
the wiring can overheat and cause a fire.
-----------------------------------------------------
SYMBOLS ON THE TOOL:
V.................. volts
A.................. amperes
Hz................ hertz
W................. watts
~
................. alternating current
4 Overview
See page 3.
1 Current Control dial
2 Rotary switch On/Off/Automatic/Vibrator
3 "Filtercontrol" lamp
4 Plug socket for power tool
5 Carrying handle
8
6 Upper part
7 Locking bar
8 Locking knob
9 Suction opening
10 Container
11 Snap lock
12 Paper filter bag *
13 PE filter bag
14 Motor protection filter
15 Filter cartridges
*equipment-dependent
5 Initial Operation
Before plugging in check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply.
5.1
Stick the carrying handle (5) into the support
provided for it on the container (10) and secure
with the quick-release locks provided.
5.2
Insert the axles of the guide rollers in the holes
in the container until they engage.
(see table,
max
Fit the large wheels as shown:
6 Use
6.1
Select the mode via switch (2):
0 = Dust extractor off
I = Dust extractor on (manual operation)
A = Automatic On/Off switch:
R A = Automatic On/Off switch and
Attaching the carrying handle
Fitting wheels (if necessary)
On/Off switch, automatic, vibrator
The dust extractor is turned on and off by a
power tool (4) connected to the mains
socket.
automatic vibrator
• If the switch (2) is turned to position R A,
the electromagnetic vibrator switches on.
Dust is shaken off the filter. The vibrator
Publicidad
