cecotec READYWARM 2250 CURVED FLAMES CONNECTED Manual De Instrucciones página 35

1. PARTS AND COMPONENTS
Fig. 1
1. Power on/off
2. Power heat 1 (1000 W)
3. Power heat 2 (2000 W)
4. Temperature
5. Day of the week
6. Timer on
7. Timer off
8. Open window indicator
9. Brightness
10. Time (hours/min)
2. BEFORE USE
- Take the product out of the box.
- Remove all packaging material. Keep the original box.
- This device is designed to be installed on a wall or on an included base.
- Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Technical Support Service immediately.
3. PRODUCT ASSEMBLY
Installation of the stones in the fireplace
1. First unscrew the 2 screws at the top, then remove the glass panel. Fig. 2
2. Next, place the stones on the base, then fix the glass panel and screw the two upper
screws. Fig. 3
Wall assembly
1. This appliance is designed to be fixed to a wall at a minimum height of 30 cm and the
minimum distance from the top of the heater to the ceiling must be 100 cm. The wall
bracket must be installed horizontally and the cable must be routed to the bottom right
of the heater.
2. It is recommended to leave a distance of at least 60 cm between the bottom of the heater
and the floor for an optimal visual effect.
3. Drill two holes with the 8 mm drill in the wall (See Figure 1) D= 267 mm
4. Insert the plugs into the holes and tighten them firmly with the screws provided. Fig.4
05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 35 05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 35
READYWARM 2250 CURVED FLAMES CONNECTED
ENGLISH
35
16/7/21 9:53 16/7/21 9:53