cecotec READYWARM 2250 CURVED FLAMES CONNECTED Manual De Instrucciones página 7

SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is grounded.
- This product is designed only for household use. Do not use
for industrial or commercial purposes.
- Not for outdoor use.
- Check the power cord regularly for visible damage. If the
cord is damaged, it must be replaced by the official Technical
Support Service of Cecotec in order to avoid any type of
danger.
- Furniture, curtains and other flammable materials must be
at least 1 metre away from the device.
- Do not place the power cord in front of the device.
- Do not place the appliance close to heat sources, flammable
substances, wet surfaces where it can fall or be pushed into
water or allow it to come into contact with water or other
liquids.
- The appliance must not be placed immediately below a
socket.
- Always unplug the device when not in use.
- To disconnect the device, turn all controls to the off position,
then disconnect the plug from the power supply. Pull the
plug to disconnect, not the cord.
- Ensure the walls where the device is going to be installed
present no damage and that they are in good and safe
conditions.
- This device must be used under AC voltage.
- This device must be connected to an earth ground.
- This heater is not equipped with a device to control the
05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 7 05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 7
READYWARM 2250 CURVED FLAMES CONNECTED 7
16/7/21 9:53 16/7/21 9:53