cecotec READYWARM 2250 CURVED FLAMES CONNECTED Manual De Instrucciones página 36

ENGLISH
Note
Tighten the screws securely. Do not tighten the screw in the expandable tube fully; the
length of the bare parts must be 10 mm.
5. Mount the fireplace on the wall (See figure 4).
4. OPERATION
Control panel
This is located on the right side of the fireplace. It takes some time for the receiver to respond
to the transmitter. Do not press the buttons more than once within two seconds for proper
operation.
Power switch
ON(I). Allows all functions
OFF(O). Turns off all control functions
Power button
Press this button once to turn the machine on. The device will switch on and is ready to select
any of its functions. Press this button again and the device will turn off.
Timer
Press this button and "+" or "-" to set the real time, the day (Monday-Tuesday-Wednesday-
Thursday-Friday-Friday-Saturday-Sunday), the hour and the minutes.
Increase/decrease brightness
Press this button to increase or decrease the brightness of the flame.
Setting 5 is the brightest grade and setting 1 is the least bright grade. Brightness adjustment
is made on a scale of 1-2-3-4-5.
Heat
Two settings. Press once for low heat, press twice for high heat, press again to turn off the
heating, and the fan will continue to run for 10 seconds after the heating is turned off.
Note
The device will switch off automatically when the temperature drops by 5 to 10°C suddenly.
The corresponding indicator lamp will light up. (Open window symbol)
Remote control operating Fig. 6
36 READYWARM 2250 CURVED FLAMES CONNECTED
05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 36 05813_ReadyWarm 2250 Curved Flames Connected_IM_YV_01210713.indd 36 16/7/21 9:53 16/7/21 9:53